• Standard PMC Mezzanine form factor IEEE 1386.1
• Uses standard parallel ATA drives
• On board parallel to serial ATA conversion
• SATA control logic supports Hot Swap
• Off-the-shelf device driver support
• One design is compatible with 1.8” – 7 mm ATA hard drives, and 2.5” - 9.5 mm ATA hard drives. (Host board component height cannot exceed 2.5 mm for 9.5 mm thick hard drives)
• On board Hot Plug Power conditioning
• Activity and Hot Swap Indicators on the front panelPMC

• Compact, removable storage
• Standard PCI Mezzanine (PMC) form factor (IEEE P1386.1)
• Complete solution, with drive(s), interface and software driver provided
• High quality, optimized multilayer design
• Option to bring interface out the rear of PMC
• Up to 160 GB currently available

Compatibility
Compliant with PCI Local Bus (v. 2.1), supporting boards that provide PMC sites designed to IEEE P1386.1. The disk controller is ATA/ATAPI-5 compliant. The PMCStor supports universal signaling and operates at 3.3 volts, tolerating 5 volt I/O. The PMC ShuttleStor may be used on any board supporting standard PMC sites such as CompactPCI and VMEbus single board computers. We have a selection of SBCs on which the ShuttleStor has been functionally pre-qualified.

Software compatibility: Hot-swap and non hot-swap drivers available for Windows, VxWorks, and Linux. Other O/S support is available on request.

Interface
Typically, no other cabling is required to use the PMC ShuttleStor since the drives are on-board. Versions are available supporting
external disk I/O from the front or from the rear of the PMC.

Environmental Specifications (board only)
Contact ACT/Technico regarding board environmental specifications including various hard drive options.
• Operating temperature, w/o hard drive: 0° C to +70°C
• Operating temp. w/commercial hard drive: +5° C to +55°C
• Storage temperature: -40°C to +85°C
• Operating humidity: up to 90% non-condensing with drive
• Non-operating humidity: 5% to 95% non condensing
• Operating shock: 15G, 11ms
• Operating vibration: 1G, 5 to 500Hz
Designed for optional conformal coating

Power Requirements (Max)
Without HDD: With HDD:
• 5V @ 52 mA 1.152 A
• 3.3V @ 392 mA 392 mA

LED Indicators
Status, activity and alert LEDS are located on the front panel.
Yellow: activity
Blue: hot-swap ready
Red: overcurrent warning

IDE/ATA Controller Specifications
• SATA 1.5Gbps
• SATA 1.0 compliant
• 256MB DMA FIFO
• 32 bit / 66Mhz PCI interface
• 48 bit sector addressing

SATA to ATA Bridge
• Generation 1 SATA speed of 1.5 Gbps
• Selectable max speeds, 66/100/144/150 MBps
• Ultra low power consumption

Disk Parameters/Specifications
Drive specifications change on a regular basis. The following parameters are common to most drives. Please call us for all current drive specifications.